Renumber Work Locations Dialog
Lets you modify both point and span work location(s) names. There are functions to modify one or multiple work locations and functions to continue the pattern to the rest of the work locations. You can also customize the tool for a specific scheme.
| Setting | Description |
|---|---|
| Points | This contains the list of point work locations selected by the user. If the user selected a path, then all point work locations under that path will be displayed in this list. For each point work location, the "Original" name as well as the "New" name will be displayed. The user can type directly into the "New" column, or drag and drop from one place in the list to another. |
| Spans | This contains the list of span work locations selected by the user. If the user selected a path, then all span work locations under that path will be displayed in this list. For each span work location, the "Original" name, the "New" name and the names of the point work locations on either end of the currently point work location will be displayed. |
| Increment |
Increments the select work location(s). |
| Decrement | Decrements the select work location(s). |
| Move Up | Moves a specific work location up in the list. |
| Move Down | Moves a specific work location down in the list. |
| Renumber from Selection | Renumbers the remaining work locations starting at the current selected work location in the list. It will follow a sequential scheme. |
| OK | Applies the new name(s) for the work location(s) to the design. Depending on your specific configuration, this may or may not allow duplicate work location names. For GIS designs, the work location(s)'s annotation will be updated. |
| Cancel | Closes the dialog without saving any changes. |
| Custom | Opens a custom dialog for specifying custom attribute values. This button appears dimmed if no custom dialog is available. |
| More | Disabled if not configured. If configured, used to pass the content of the two lists to custom code for changes. The dialog would then reload the lists from the code. This can be used for custom renumbering schemes. |